User manual

USING THE 907X
www.hasselblad.comCONTENTS
64
907X 50C USER GUIDE
Control Screen
Live View
FOCUS BRACKETING OPERATION
An active and pending Focus Bracketing function
is indicated both on the Control Screen and in
Live View ( A ).
In the example on the right, the Focus Bracketing
sequence will take 40 images.
To start the sequence, simply press the shutter
release and all captures will be made automati-
cally. If required, you can set a delay before the
rst capture. A separate delay can also be set
between frames to minimize vibration or to allow
a ash to charge.
During the Focus Bracketing sequence, the rear
screen will show the selected Browse Overlay
with an extra information overlay, as shown in (
B ).
1 Focus Bracketing Icon
2 Remaining captures
3 Number of captures in the sequence
4 Focus adjustment step between captures.
To exit from the sequence before it has been
completed, press the Cross Button ( 5 ).
After a completed sequence, the last image will
show up on the rear screen.
Note!
The Focus Bracketing function requires a
rmware update for the Lens. Use version 0.5.33
or later for XCD lenses. The XCD 45P requires
version 0.1.24.
Note!
HC/HCD lenses cannot be used for Focus
Bracketing.
Note!
Focus Bracketing is not supported in Phocus
Mobile or when tethered to Phocus.
Note!
Light measurement, focusing and Auto White
Balance are performed before the rst exposure
and is applied to all images in the sequence.
A
A
1
B
2 3
4
5