Service Manual, Diagrams and Assembling Charts

January 2001
903SWC
Reassembly
4:5
Revision 0
90303.EPS
001026
90302.EPS
001026
90301.EPS
001026
Fig. 20
Re-install the rear lens group with the help
of wrench 104117 0064 903.
Fig. 20
Install the cone (13435-1).
Fig. 21
Fit the rear plate (22603). Secure with the
four screws (823640). Check that the rear
plate is aligned with the rear edge of the
camera shell. If necessary adjust with
washers.
Note! The rear plate must not protrude over
the shell at any point.
Fit the intermediate foot (22821).
Secure with the two screws (823783) and
one (823780).
Fit the tripod foot (30735) with the four
screws, two (829790) and two (829760).
Fig. 22
Mount the viewfinder.
Fig. 21
Fig. 22
13435-1
823780
829760
823783
829790
823640
30735
22821