Repair Guide, Diagrams and Assembling Charts
Table Of Contents
- Service Manual 203FE - 205FCC - 205TCC Cover
- Content list
- Related Service Infos
- 1. General description
- 2. Specifications
- 3. Checks & Adjustments
- 4. Tools
- 5-22 Exploded Views and Spare Part lists
- 5. Shell
- 6. Control panel, mechanics
- 7. Control panel, electronics
- 8: Display flex and main circit board
- 9. Contact flex and transport mechanism plate
- 10. Transport mechanism plate
- 11. Front bayonet plate
- 12. Curtains and rear plate
- 13. Mirror assembly
- 14. Display prism and fucusing screen
- 15. Chassis
- 16. Reflection protectors
- 17. Bottom mechanism plate, mechanics
- 18. Bottom mechanism plate, brakes
- 19. Bottom mechanism plate, electonics
- 20. Spring housing
- 21. Winding crank
- 22. Winding crank - modified from May 1997
Camera body 203FE - 205FCC - 205TCC
50
1
1
200
250
50
1
1
200
250
GRAM
Checks & Adjustments 3:5
VHAB Tool No. = ZZ88, Scale
Magnet hold capability
The magnet hold capability can be checked according to the diagram below. A suitable
scale, like the ZZ88, should be used. When measuring, it must indicate minimum 2 NCM
(200 gram) before each latching lever is released.
If indicating less then 2 NCM, the magnets should be cleaned and then rechecked. If still
less then 2 NCM after cleaning the Bottom mechanism plate, compl. (Part No. 105028)
must be changed. Magnets and latching levers are not available as spare parts due to
sensitive calibration procedures.
Magnet 2
Magnet 1
The magnets can be released from the
main circuit board when troubleshooting.
Use an external DC power supply and
apply 5 volt to the test points indicated.
Do not forget the grounding.
May 1997Revision 0