Service Manual

Camera body 201F
Checks & Adjustments 3:9
50
1
1
200
250
50
1
1
200
250
GRAM
COPYRIGHT © 1994 ANDERS ENGSTRÖM
ANDERS ENGSTRÖM, ILLUSTRATÖR
Östra vägen 46
430 91 HÖNÖ TEL/FAX [phone]
Flash meter
Sync contactsCurtain brakes
2nd Curtain drive spring
1st Curtain drive spring
ADJUSTMENTS
Shutter speed 1/1000 s
C-Mode
ADJUSTMENT DIRECTION
+ –
+
–
+
–
+
–
April 1998Revision 0
VHAB Tool No. = ZZ88, Scale
Magnet hold capability
The magnet hold capability can be checked according to the diagram below. A suitable
scale, like the ZZ88, should be used. When measuring, it must indicate minimum 2 NCM
(200 gram) before each latching lever is released.
If indicating less then 2 NCM, the magnets should be cleaned and then rechecked. If still
less then 2 NCM after cleaning the Bottom mechanism plate, compl. (Part No. 105028)
must be changed. Magnets and latching levers are not available as spare parts due to
sensitive calibration procedures.