Manual

39
7. Lighting the Fire
Theringupphaseshouldbeasshortaspossible,
since higher emissions can occur during this phase.
The slider settings described in Table 1 are recom-
mendations that were determined under confor-
mance testing conditions, in compliance with the
relevant standard. Depending on the weather con-
ditions and the draught capability of your chimney,
accordingly adjust the slider positions for your Luno
to the local conditions.
NOTE!
The Luno may only be operated when the
re box door is closed; the re box door
may only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other amma-
ble uids to light the stove.
Lighting the Fire
Procedure Position of Control
Elements
Completely open second-
ary air.
Pull air slider all the way
out.
Pile up any remaining ash
and unburned charcoal
into the centre of the
combustion chamber.
Closeregrate. Pushinregrateslider.
Place 4-6 small pieces of
wood with an approx. Ø
of 3-6 cm and max. 2 kg
in the middle of the burn-
ing chamber. Layer these
cross-wise on top of each
other. Place approx. 0.5
kg of wood shavings on
topasarelighter.
Delhi
Light the kindling/ignition
material.
Tab. 1
8. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the re when the
amesfromthepreviousburningoffphasehavejust
gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust secondary air. Set air slider between
position 1 & 2.
Closeregrate. Pushinregrateslider.
Add two logs weighing
approx. 1.3 kg in total.
Place logs with the end to
thefrontofrebox.Only
add a single layer of fuel.
Tab. 2