User Manual

34
5 . Operating the Revolving Console
The Lima has a maximum rotational angle of 180 de-
grees; you can adjust the rotational angle in 15-de-
gree increments.
Unlock the rotary console by briey pressing the
button A and then turn the Lima to the desired po-
sition.Shortly before thenalpositionis reached,
press the key A again and lock the stove into place
with a slight rotational movement.
 g. 3
A
WARNING!
Never turn stove when lighting  re!
In the whole rotational area range, the safe
distances (radiation area) apply to distanc-
es to  ammable materials.
2. Vorbereitung zur Montage
2.5 Drehwinkel am Aufstellort einstellen
 g. 4
2. Vorbereitung zur Montage
2.5 Drehwinkel am Aufstellort einstellen
 g. 5
6 . Initial Operation
NOTE!
During shipment, condensation moisture
can accumulate in the stove’s interior,
which may possibly lead to the appearance
of condensation or water on the stove or
 uepipes. Please dry off these damp areas
immediately.
The surface of your stove was treated in a sand-
blasting machine before applying the colour coating.
Despitecarefulandthoroughinspection,theremay
still be some residual material in the stove body,
which can fall out when your stove is being installed.
NOTE!
To prevent any damage, please immedi-
ately vacuum up these small steel pellets
with a vacuum cleaner.
Thersttimeastoveisoperated,theheatdevelop-
ment causes the emission of volatile components
fromthecoating,sealingstripsandlubricants,and
smoke and odours can occur.
Atahighercombustiontemperature,thisone-time
process can take between 4 to 5 hours.
To achieve this higher combustion temperature,
please increase the fuel quantity recommended in
Section8,„AddingFuel/HeatingwithNominalTher-
malOutput“,byapproximately25%.
CAUTION!
To prevent adverse effects on health, no-
body should stay in the room(s) during