Interactive Sounds 'n Vibes Driver Instruction Manual

ManualsBrandsHasbro ManualsGameSounds 'n Vibes Driver 05949

Includes 2 x 1.5V "AA"/R6

batteries. Alkaline batteries

recommended.

Phillips/cross head

screwdriver required to

replace batteries.

Sounds ‘n Vibes Driver

™

OVER 6 months

05949

Summary of content (4 pages)

PAGE 1
OVER 6 months 05949 Sounds ‘n Vibes Driver ™ Includes 2 x 1.5V "AA"/R6 batteries. Alkaline batteries recommended. Phillips/cross head screwdriver required to replace batteries.
PAGE 2
To Replace Batteries Using Phillips/cross head screwdriver, loosen screw in battery compartment cover (screw remains attached to cover). Remove cover. Remove and discard batteries. Replace with 2 x 1.5V "AA"/LR6 alkaline batteries. Replace cover and tighten screw. CAUTION: TO AVOID BATTERY LEAKAGE 1. Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions; 2.
PAGE 3
IMPORTANT: BATTERY INFORMATION Please retain this information for future reference. Batteries should be replaced by an adult. CAUTION: 1. Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings. 2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. 3. Remove exhausted or dead batteries from the product. 4.
PAGE 4
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.