FAQ

Q What is the curing time for pipe joint compound?
A Under normal pressures, the pipe joint compound does not need a curing time. If the pressure in the
lines is 125psi or higher, the recommended cure time is 4 hours before initiating pressure. Call Oatey
Customer Service when in doubt.
Q Why is the pressure limit for natural gas and LP gas listed at 125psi on the submittal sheets
and containers?
A This is because of UL listing requirements.
Q Can pipe joint compound and thread sealant tape be used on the same joint?
A Yes. Once the male threads are wrapped properly you can apply a coating of pipe joint compound over
the thread sealant tape before assembling the joint. Remember that you only apply pipe joint compound
to the male threads.
FAQs
Thread Sealants