Installation Guide

5
1. Installation of Dual Channel Processor (DCP)
The Dual Channel Processor (DCP) has the same bolt pattern as the Precision Information Processor (PIP)
you will be removing. The location of the main controller does not change so use the same holes and install
the new Dual Channel Processor (DCP) in the same location with two 5/16” x 1” bolts, two 5/16” x 1-1/4” bolts,
locks, fender washers and hex nuts. Mount the DCP cover over the top of the DCP and secure with the
hardware using the 5/16” x 1-1/4” bolts on the top with the DCP shield.
DCP or PIP Location
AGCO Balers
Figure 1
Figure 2