Installation Guide

4
Introduction
Thank you for purchasing a HayBoss G2 Model 696M Hay Preservative Applicator. This 696M applicator
system has been designed to plug directly into the baler’s ISOBUS and display on a C1000 monitor. As well as
the option of operation through an Apple iPad (not included) using the Hay App. The 696M Preservative
Applicator System offers these advantages:
1. Operation coordinated with baler operation
2. Less cab clutter providing better visibility
3. Ease of use with all information on one screen
4. Records kept together
5. And the system is ready for future updates.
This manual will take you through the steps for installing the automatic applicator. If you are unsure about
installing the system after consulting this manual, please contact your local authorized dealership for additional
assistance. If you are in need of parts for the system please see the parts breakdown in the back of this
manual and contact your local authorized dealer to order the parts.
Right and Left sides are determined by facing in the direction of forward travel.
System Requirements
The Baler Processor must have Version 3.3 or higher.
C1000 must have version 3.0.1 or higher
*Requirement to run iPad, running the current iOS operating system or one version previous. Krone
ISOBUS integration requires harness 006-6650VAK.
**600 Series Applicators with serial number before DCP27000 will require the DCP to be sent to Harvest
Tec for a required update in order to use the iPad Integration Module (030-6670C).
*Hay App version must be at least 2.5.18 (or higher) to operate with the iPad Integration Module (030-6672C)
If choosing to operate the unit though the ISOBUS monitor, pn 006-6670A will need to be ordered through your
local equipment dealer. 2018 Krone balers (and beyond) Serial Number 976909 will need pn 006-6650VAK.
Tools Needed:
- Standard wrench set
- Side cutter