Instruction Manual

27
Display says PAC error
1. The DCP and Pump controller
are not communicating.
2. Broke connection between the
display and DCP or Pump control
and DCP.
1. Check all connections at DCP and
Pump controller including terminating
resistors.
2. Check, clean, and tighten
connections.
Can’t select moisture / preservative
information on baler run screen
DCP not selected in baler software
Select DCP for the moisture option in
machine setup. See Communicating
through ISOBUS Monitor section in
operation manual
‘?’ or ‘---‘ for moisture values are being
shown on baler run screen
CNH software must see a stuffer
cycle before it will update the
moisture values
Simulate a stuffer cycle on baler, or wait
until baling in the field and the moisture
will update
Job records are showing as symbols or
incorrect values
The job file is corrupted on SD card
Write down all job record information the
operator wishes to keep. Update the
DCP software to the most current
version available on the Harvest Tec
website. Delete all existing jobs by
selecting all in the download screen and
pressing delete. Be sure to start a new
job an verify it is saved by checking job
details screen.
Values in auto / manual mode are
obscure
The job file is corrupted on SD card
System needs to be sent to Harvest Tec
for repair.
Can’t download job records, stuck at
“Saving to USB Stick”
One of more jobs are corrupted on
SD card. If “saving to USB” is
displayed, some jobs have been
downloaded correctly.
Bale rate goes to zero and prox
sensors/star wheels check out fine
DCP is set to use “Bale Rate
Sensor” from baler in calculation
and baler does not have this option
installed
Turn off Bale Rate Sensor in baler
sensors screen, make sure Auto baling
rate is turned on in baling rate setup
screen
Bluetooth Receiver lights will not
illuminate
1. Bluetooth receiver not
connected
2. Harness disconnected
3. Low power
1. Check connections and voltage.
Minimum 12.5V needed.
Blinking Lights – System is waiting for the processor to connect, which
could take up to 35 seconds.
Red Light – The Bluetooth receiver has power
Green Light – When the proper active connection is selected in the Hay App
menu, the green light will indicate connection with the iPad.