Instruction Manual

25
Common Questions
1. How do I turn the system on/off?
Turn the key in the tractor to the on position. If the unit is in Standby Mode, press anywhere on the
screen. To turn off, press the Standby key, wait for the screen to power down and turn off the key.
2. How to get in the LBS/TON, MC%, and TONS/HR menus?
In the Main Menu press the SETUP MODE key. From this screen you can change your application
rates and how much product is applied. See SETTING UP FOR INITIAL USE for a detailed explanation
of this process.
3. The unit is stuck in the MC% screen.
In the MC% screen, level 1 must be less than level 2, and level 2 must be less than level 3. For
example, if level 1 is set at 16, level 2 must be set at 17 or higher, and level 3 must be set higher than
level 2.
4. How does OVERRIDE work?
Override turns on all three pumps at full output. The pumps will remain at full output until the operator
turns these pumps off by pressing the OVERRIDE key again.
5. The flow meter reading is more or less than the programmed level set in the box.
Some variation in flow meter readings compared to the programmed set point is normal due to factory
tolerances on the pump motors as well as varying tractor voltages inputted to the control box. The flow
meter reading is an accurate measure of how much product is actually being applied. The set points
then will need to be adjusted if you want to attain a different flow meter reading.
6. Why don’t all the pumps turn on even at higher application rates?
The selections of what pumps turn on when are automatically controlled by the control box’s flow rate
look up chart. Thus, not all the pumps turn on at once and the combination of what pumps turn on when
is automatically controlled by the software. If you want to make sure all three pumps are working, go to
the Diagnostics screen and run pump outputs.
7. The moisture content displays “LO” or “HI” all the time.
When the moisture content display does not change frequently while baling, there is likely a faulty star
wheel connection. One of the first places to check is inside the white star wheel block. Check to see if
the electronic swivel is in the star wheel shaft and check to see that the star wheel shaft is not working
out of the block. Also, check all star wheel wires and connectors to see if there is a continuity or
grounding problem.
8. Should the battery connections be removed before jump starting or charging a battery?
Yes. Anytime the tractor will have voltage going up rapidly the connections should be removed.
9. How do I recalibrate the touch screen display?
In the system diagnostics screen press the Recalibrate Touch screen key and follow the directions on
the screen. Press accept when done.
10. How can I turn the optional Hay Indicators on/off from the cab?
In the Setup Mode screen press options. Press the on/off underlined area next to EOR sensor.
11. What do the lights on the 030-6672B indicate?
Pre-2020 applicators were equipped Bluetooth receivers (030-6672B) and are now equipped with lights
to indicate both power and Hay App connection on the Apple iPad.Red Light – The Bluetooth receiver
has power. Green Light – The Bluetooth receiver is connected to the Hay App