Instruction Manual

Operation Instructions

Automatic mode will automatically apply product based on hay moisture content sensed by the moisture

sensors and the operator’s presets. See SETTING UP SYSTEM FOR INITIAL USE to change any of these

settings. Manual mode will apply preservative to the hay at a fixed rate regardless of the moisture.

Automatic Mode

After pushing the AUTOMATIC MODE key in the Main Menu screen, the following screen will appear:

iPad

1. To pause the unit while in operation select the Pause key.

2. Push the OVERRIDE key to turn on all three pumps at the same time for full output of the system. Use this

mode when going through a short area of wet crop.

3. The moisture content is shown in the upper right hand corner.

4. Baling Rate and Application Rate are shown in the middle of the screen. The operator sets the target

application rate and baling rate in the setup mode; the actual rate should be within +/- one pound.

5. Volume used and strokes per bale are shown at the bottom of the screen will show accumulated pounds of

preservative used on the go. This number will reset at power down, but remains in the job record screen.

NOTE: Initial start-up requires pressing the New Job key in the Job Records screen in order for

Volume Used accumulation to be recorded. This only needs to be done once on initial start-up of

system and not every time the system is started for operation. (See JOB RECORDS screen)

6. The graph shows the moisture trend from the past 90 seconds in 3 second intervals.

7. The DCP button shown when using an iPad displays your connection signal with the Bluetooth receiver.

Green – DCP is connected, Yellow – DCP is connecting, Red – DCP not connected.

8. Press the MAIN MENU key to return to the opening screen.