Instruction Manual

5
Mounting Control Box
Locate the controls package. Position the control box (006-3671RB) as
shown on right. If the mounting holes are not pre-drilled on the tank saddle
(001-4442), drill four 1/4" (7mm) holes. Using the supplied 10/32 x 3/4”
Phillips flathead machine screws, nylock washers and nuts to mount the
control box.
Placement of Nozzle Holders
Install Kit 347U
The cross bar on the wind guard above the pick-up head provides a mounting point for the nozzle holders
(001-4714J). Mount the nozzle holders on the wind guard, using the supplied U bolts (001-4714UBS).
Measuring from the center of the baler, the nozzle holders will need to be 6” (15cm) apart on a 4’ (1.2M).
Position the nozzle holders so that the tips spray in a horizontal direction over the top of the baler’s pickup. The
tips should be located so that they will be between 14” and 18” (35 - 45 cm) from the normal path of hay. Make
sure the tubes do not interfere with the tying system. *It is recommended to test the system with water prior to
field operation. This will ensure the fan pattern from the tips reaches the outside edges of the pickup while
having a slight overlap in the center.
Installation of Plumbing
A. Intake
Locate parts bag 16. Use the 003-EL3412 on the bottom of the tank to route 1/2" line (002-9001) to the
003-A1212 or 003-EL1212 fitting used on the ball valve attached to the pump plate. Attach hose clamps
(003-9003) on both of the fittings.
B. Discharge
Route the 1/2" hose from the pump output toward the front of the baler and connect to the solenoid
assembly (SOL-3SP-A). Secure the solenoid assembly and hose along baler, positioning the solenoid as
close to the spray tips as possible. Connect the 1/4" hose to the outgoing side of the solenoid to tip
assembly.
C. Low, Standard and High Output Tips
Your baler comes with two sets of tips: a low set and a high set.
-Low set will cover outputs of 60 - 300 lbs/hr (27-300 L/hr).
-Standard set will cover outputs of 48- 448 lbs/hr (21-203 L/hr).
-High (optional) set will cover outputs of 80-800 lbs/hr (36L-363L).