Instruction Manual

3
Harvest Tec 347U Table of Contents
Page
Introduction
3
Tools needed
3
Installation of applicator
4-7
Installation of Tank, Mounting Brackets & Drain / Fill line
4
Mounting Control Box
5
Installation of Nozzle Holders
5
Installation of Plumbing
5
Installation of Moisture Sensing Pads
6
Installation of Bale Sensor
7
Installation of iPad Integration Control
8
iPad Integration Control Light Signals
8
Bluetooth Receiver Lights
8
Wiring Diagram
9
Pin Outs
10-11
Parts Breakdowns
12-19
347U Base Kit
12
Moisture Sensors
12
Pump Assembly
13
Control Box and Wiring Harnesses
14
End of Bale Sensor Kit
14
300 Solenoid Package
15
Hoses
15
Parts Bag Packages
16
Optional iPad Mini Mounting Kit
17
Optional iPad Display Kit
18
347U Install Kit
19
Notes
21-22
Warranty Statement
23
Introduction
Congratulations and thank you for purchasing a Harvest Tec Model 347U applicator. Please read this manual
carefully to ensure correct steps are taken to attach the applicator to the baler. This applicator is designed to
apply Harvest Tec buffered propionic acid. Use of alternative products may cause complications. Including
inaccurate readings from the flow meter and damage to all parts. Resulting in the warranty being void. A parts
break down for the applicator is located in the back of the manual.
*Made for iPad
®
running the current iOS operating system
*iPad is a trademark of Apple Inc., registered in the U.S. and other countries.
300 Series Applicators with serial number before THS07000 will require the THS to be sent to Harvest
Tec for a required update in order to use the iPad Integration Module (030-6670C).
Hay App version must be at least 2.7.1 (or higher) to operate with the iPad Integration Module (030-6672C)
Tools Needed
- Standard socket set
- Side cutter
- Crescent wrench
- Metal drilling and cutting tools
- Standard screw driver or 5/16”
nut driver
- Hose cutter
- Hammer
- Center Punch