Reference Manual

HE1074-915 Radio module – Reference manual 5(10 )
Regulatory conformity summary
No modifications to the module HE1074-915 made by other than Hartvik Engineering AB are
allowed to ensure that the products approval of FCC and IC regulation is sustained.
Modules were tested and found to comply to the regulations using Linx ANT-916-CW-HW-SMA
halfwave center-fed dipol antennas, only equal or similar antennas must be used and gain can not
exceed 2dBi.
Only antennas and other peripheral approved by Hartvik Engineering AB must be used.
FCC and Industrial Canada (IC) notices
Testing for unintentional radiators of end product with the HE1074-915 built in must be done to
verify that it achive approval of FCC rules Part 15 (eg 15.107 and 15.109) respectively IC-003 for
Canadian regulations.
Labeling
The FCC ID of this radio module must be included clearly visible on the final products outside label
to comply with part 15 of FCC regulations.
Part 15.19(a):
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Part 15.105:
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Part 15.21:
NOTE: The user is cautioned that any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Part 15.247:
NOTE: This equipment will meet the requirements of FCC part 15.247, the same must applies to
the host.