User Guide

86
Module: Resynator
Resynator: Handling
If you are working in setup mode, you must first
prime the sound that you want to edit (see page 66)
or switch to sound mode!
How to load a model into a resynator:
• Activate the given resynator (on/off button).
• Press model select. Model loader appears in
the main display. Here’s an example using
resynator 1:
• Twist the knob to scroll through the model
database until you find the desired model. The
model number flashes until the selected model
is loaded. Load the model via enter (press the
knob).
Alternative:
Type in the three-digit model number on the
numeric keypad. The model loads immediately
after entering the third digit. You do not have
to press enter.
• The display reads:
Note in this context the basic settings parameter
ResyParReset. Use it to determine whether the model
is loaded into the resynator with the default values
stored in the database or if the current settings are
retained. A prompt may appear depending on
parameter setting. The basic settings parameter is
described on page 38.
Picture the following: The ResyParReset parameter
is set to yes/ask. You have run into a sonic dead-end
while editing the model, but you do not want to or
cannot use the snapshot function (see page 52) to
recall the initial parameter values. In this case,
simply load the default model values back into the
resynator and start over!
Neuron.book Seite 86 Montag, 23. Dezember 2002 2:28 14