User Guide

66
Module: Programmer
Example: Press sound 2.
Dial in the desired sound number using the knob and
confirm with enter (press the knob).
Stick.left and stick.right to move the cursor so that
you can load sounds to the other positions in the
setup.
How to prime a sound for editing within a
setup
The aforementioned sound 1 to 4 buttons also serve
to do this.
When you press a button repeatedly, the assigned
sound is activated (LED lights up), primed (LED
flashes), or deactivated (LED extinguishes).
If you want to mute an activated sound without
priming it first, press and hold the appropriate
sound button until the LED extinguishes (one
second should do).
An activated sound is played with the setup while a
deactivated sound is muted. A primed sound can be
edited by means of the module’s control features
while the current setup is being performed.
How to store edited sounds in a setup
Sounds are reference by (or linked into) a setup. If
you edit a sound’s parameters within a setup because
you want it to sound a bit different in the setup than
it does in sound mode, you must store these changes
specifically. Simply storing the setup will not save
these changes.
Setup mode offers an enhanced store function for
this very purpose.
• Press the red store button.
You can now select in the display what you want
to store:
Use the knob to select the setup-specific
parameters or one of the four sounds to be
stored.
All changes - for example, parameters edited via
stick in the resynators, or in slicer or silver - always
apply to the primed sound and are audible in the
setup without having to first store the edited
sound or load the edited sound into the setup.
Neuron.book Seite 66 Montag, 23. Dezember 2002 2:28 14