User Guide

Module: Programmer

How to start setup mode

All the procedures described in the following section

require that Neuron is running in setup mode.

To start this mode, press the setup button located

below the main display. The LED above the button

lights up when Neuron is in setup mode.

How to load a setup

Start setup mode as described above. Setup loader

appears in the main display along with the number

and name of the currently loaded setup.

You have three options for loading a setup:

• In order to step through all stored setups

successively, press the up or down button in

programmer. In each step, the next setup is

loaded and indicated in the main display. (You

can only do this when setup loader is

displayed.)

• Enter the three-digit setup number using

programmer’s numeric keypad (whenever

necessary, preceded by zeros, e.g. 003). The

setup is loaded immediately after the third

digit is entered. (You can only do this when

setup loader is displayed.)

• Dial in the setup number by twisting the knob

next to the display and confirm with enter (by

pressing the knob). The setup number

continues to flash until the selected setup is

loaded.

When you load a setup, all modules are set to the

stored values.

How to load a sound into a setup

Located above the main display you will find four

buttons labeled sound 1 to sound 4. Every button

represents a sound stored in the current setup.

If you press one of these buttons when the device is

in setup mode, the display jumps right to the menu

option that lets you load sounds and the cursor

points to the desired position.

If you are already working in setup mode, call setup

loader by briefly pressing exit once or twice

(depending on the currently active menu).

Neuron.book Seite 65 Montag, 23. Dezember 2002 2:28 14