User Guide

Module: Programmer
63
Reverb Determines the reverb send amount for the
individual sounds. The master effects module
processes the composite signal of all four
sounds, meaning that the reverb settings
apply to all sounds within a setup. This
parameter lets you determine the send
amount for each sound individually.
Surround
Stk Ani
Defines the playback mode for stick
recordings in surround mode (stick playback)
for each sound.
• Off: Stick animation is disabled for the
given sound.
• 1Shot: The first note you play triggers the
recorded stick movement for the given
sound (single trigger) and the animation
continues to shape the sound regardless of
how many notes you play thereafter. Once
the animation has run its course it is not re-
triggered.
• Repeat: The first note you play triggers the
animation and then – unlike when the 1shot
setting is enabled – it is repeated in cycles
for as long as you continue playing notes.
To learn how to record stick controller
movements, read the topic "Stick recording
and animation" starting on page 89.
Table 5: Setup parameters (cont.)
Surround
FrLeft
Determines the amount or level of each
sound in the left front surround channel.
Value range: 0 to 127.
0 means that the given sound is not audible
in the left front speaker.
127 means the sound is routed in the
maximum amount (or level) to the left front
surround channel.
Note that this parameter is the inverse of the
parameter for the right rear channel:
For more on this, see the comments following
the table!
Surround
FrRight
Determines the amount or level of each
sound in the right front surround channel.
Value range: see above
Note that this parameter is the inverse of the
parameter for the left rear channel:
Surround FrRight + Surround BkLeft = 127.
For more on this, see the comments following
the table!
Table 5: Setup parameters (cont.)
Neuron.book Seite 63 Montag, 23. Dezember 2002 2:28 14