User Guide

Module: Programmer
61
Setup parameters
Snd Numbers of the sounds contained in the
current setup.
Vol Sets the volume levels for the individual
sounds within the setup. Value range: 0 to
127.
Transp Transposes the individual sounds within the
setup in semitone steps.
Value range: -48 to +48.
Detune Detunes individual sounds within the setup
in cent increments.
Value range: -99 to +99.
MIDI Determines MIDI data send and receive
channel for sounds in setup mode.
A sound responds to incoming MIDI data
only when the defined MIDI channel and
send channel numbers are identical.
Value range: 0 to 16. 0 denotes omni,
meaning that the sound responds to
incoming messages on all MIDI channels (see
page 178).
In sound mode, the global MIDI channel
settings defined in the basic settings apply
(see page 40).
Table 5: Setup parameters
Local Deactivates/activates Neuron’s synthesis
engine via the keyboard as well as via
controls 1 to 4, the footswitch, the sustain
pedal and aftertouch.
Local = Off: Neuron’s keyboard is disabled for
this sound so that it cannot control the
internal synthesis engine; the controls are
deactivated. However, the sound can be
played via incoming MIDI data and send
MIDI data.
Local = On: The internal synthesis engine can
be controlled for this sound via Neuron’s
keyboard as well as via incoming MIDI data.
All controls are enabled.
Note in this context the function of the local
basic settings parameter (see page 41): If
this global parameter local is set to off, the
settings of the four setup parameters of the
same name are overruled.
Out Defines the audio output for every sound in
stereo mode.
Your options are ST1 (stereo output 1), ST2
and ST3. The headphones output receives the
same signal as ST1.
See also the illustration on page 10.
Table 5: Setup parameters (cont.)
Neuron.book Seite 61 Montag, 23. Dezember 2002 2:28 14