User Guide

46
Module: Programmer
Programmer: Control features
Programmer
Numeric keypad Keypad for loading the desired sound (in sound mode) or setup (in setup mode). When you type
in the three-digit number (where appropriate, preceded by zeros), all modules are set to the
stored values.
When loading a model into a resynator (see page 86), you can also type in the model number on
the numeric keypad.
Down and Up buttons Use the down button to scroll through stored sounds (in sound mode) or setups (in setup mode)
in descending order. Press the up button to load the next higher sound or setup. All stored data
is loaded into Neuron’s modules just as if you type in a sound/setup number on the numeric
keypad.
10’s hold button Activate this button (LED lights up) to freeze the tens numeral of the currently selected number.
The idea is to make it easier to enter a sound/setup number directly.
Example: Say sound 082 is loaded. Press 10's hold. The 08- is held in place (until you deactivate
the function by pressing the button again). Then you can press, say, 9 to switch to 089.
Store button Stores the current sound (see page 51) and setup (see page 67).
Snapshot
and
Play/compare
buttons
The snapshot function stores a snapshot of all modules’ current settings. In combination with
the play/compare button, you can audition your snapshots and A/B or compare the edited sound
to the original.
You will find detailed information and a description of how to proceed on page 52.
Table 2: Programmer control features
Neuron.book Seite 46 Montag, 23. Dezember 2002 2:28 14