User Guide

Fundamentals: Basic settings
41
Local Deactivates/activates Neuron’s synthesis engine via the keyboard as well as via controls 1 to 4, the
footswitch, the sustain pedal and aftertouch.
Local = Off: Neuron’s keyboard is disabled. It cannot address the internal synthesis engine; all controls
are deactivated. Neuron can play incoming MIDI data or serve as a MIDI master keyboard.
Local = On: The internal synthesis engine can be controlled using Neuron’s keyboard and as well as via
incoming MIDI data. All controls (see above) are enabled.
Note in this context the function of the local setup parameter, which serves the same purpose for every
sound within a setup (see page 61). If the global local parameter is set to off, the setup parameters of
the same name are overruled, meaning that all four sounds are off regardless of the respective local
parameter setting.
SysXDeviceID Defines the device identification for system exclusive MIDI messages.
Hexadecimal values range from 00 to 7F.
To learn more about this, read the section "SysEx commands (System exclusive data)" starting on page
179.
Dspl Contrast Controls the brightness of the displays. Values range from 1 (dark) to 4 (bright).
StkRec start Determines the trigger that starts stick recording.
After you press a module’s record stick button, the recording function is set to standby and the button’s
LED flashes. To actually start recording, you must activate the defined trigger, that is, either move the
appropriate stick or press any key on the keyboard. You will find further details on this starting on
page 89.
Options: Key or Stick.
Srnd Sub Hz Defines the cutoff frequency for the subwoofer channel in surround mode.
Frequencies below the defined sub cutoff frequency are sent to the subwoofer.
Options: 13 Hz to 20.2 KHz (in semitone steps).
Surround mode is described on page 169.
Table 1: Basic settings (cont.)
Neuron.book Seite 41 Montag, 23. Dezember 2002 2:28 14