User Guide

A look at control features in general
27
How to calibrate stick controllers (and
aftertouch)
• Press the basic settings button. The main
display shows the menu offering Neuron’s basic
settings.
• Stick.down the navigation stick located next to
the main display to scroll to the basic settings
menu option
• The following prompt appears:
• Rotate the first stick that you want to calibrate
several times, stirring like you would sugar into
coffee. Be sure to move it to the full range of
travel. Do this until the values shown in the
main display no longer change. This stirring
action serves to measure the stick’s maximum
range of travel. These physical values are then
mapped to the value range that is to be
covered, meaning that they are converted.
The display for resynator 1 could look
something like this:
When is calibration necessary?
All sticks and aftertouch are factory calibrated so
you do not have to do this under normal
circumstances. However, we recommend that you
re-calibrate (as described below) if:
• you are unable to access all parameter values
via stick;
• parameter values jump when you move sticks;
• the center position of the pitch bend (control
1) is no longer true to pitch;
• the keyboard aftertouch value peaks out
despite the fact that the basic settings
parameter aftertouch scale (see page 40) is
adjusted properly.
At this point you can cancel the calibration
process by pressing exit or by operating any
other module.
Neuron.book Seite 27 Montag, 23. Dezember 2002 2:28 14