User Guide

Quick Start Guide
17
If you cannot wait to find out the order and hierarchy
of modules in the signal flow, check out page 43/44
where you will find a detailed diagram that should
answer all your questions.
And now back to our guided tour.
Local on/off
You will find the Local on/off MIDI parameter in
Neuron’s basic settings. To adjust it,
• Press the basic settings button located below
the main display. The display reads
• Use the navigation stick at the left of the
display to scroll down (we call this little
exercise stick.down) until the Local parameter
appears in the display:
• Readjust the parameter value by twisting the
knob at the right of the display.
You will find the purpose, use and handling of all
basic settings parameters described in the section
starting on page 36.
You will learn more about MIDI control on page 178.
Loading and playing sounds
You have three options for loading sounds:
• Type in the three-digit sound number on the
numeric keypad (the sound loads immediately
after entering the third digit),
• or press the up/down buttons to load the next/
previous sound,
• or dial in the sound number by twisting and
then pressing the knob located next to the
display (pressing = enter).
For more insight on sound mode, check out
"Programmer: Programming sounds" starting on
page 49.
The following Quick Start Guide caters for seasoned
keyboardists and producers who have plenty of
experience with synthesizers. Follow along with
these steps and you will gain an initial impression
of Neuron’s powers without delving into detail. So
let us get down to some hands-on fun and leave the
theory for later...
Neuron.book Seite 17 Montag, 23. Dezember 2002 2:28 14