User Guide

176
Surround handling in Neuron
How to position a sound via the setup menu
in the surround sound field
• Activate setup mode and switch on surround
mode (see above).
• In the setup menu, stick.down to scroll to the
menu option
• Twist the knob to determine the amount of
sound 1 routed to the left front channel.
• Stick.down to scroll to the other menu options
Surround FrRight
Surround BkRight
Surround BkLeft
and define each value using the knob. Note that
the response of the cross-x channels is inverted
or opposite and that the sum of their parameter
values is always 127.
• Stick.down to scroll to the other menu options
SrndCenterWeight
Surround sub mix
and define each value using the knob. The
following applies to both parameters: values <
63 dampen the center/sub for the current
sound, values > 63 boost it.
• Stick.right and stick.left to adjust the same
channel for sounds 2, 3 and 4 of the current
setup.
The surround settings are stored with the setup.
How to change the subwoofer’s limiting
frequency
The limiting frequency for the subwoofer channel is
defined in the basic settings, which means it is a
global rather than a local setup parameter.
• Press the basic settings button located below
the main display.
• Stick.down to scroll through the global Neuron
parameters to the menu option
Values range from 13 Hz to 20.2 kHz. The
default setting for the limiting frequency is 125
Hz.
• Define the desired frequency using the knob.
• Exit the basic settings menu. The value is stored
automatically and is valid for every setup.
Note also in this context the surround sub mix
parameter, which you can use to boost (values > 63)
or cut (values < 63) the subwoofer channel for every
sound. See page 64.
Neuron.book Seite 176 Montag, 23. Dezember 2002 2:28 14