User Guide

Surround handling in Neuron
175
• Prime the sound that you want to position by
pressing the appropriate sound button (located
above the main display) repeatedly. The LED of
the primed sound flashes. If you want to hear
the sound in isolation, you can mute the other
three sounds by pressing and holding their
buttons for about half a second (until the LED
extinguishes).
• Move the stick controller in the silver module to
the desired position.
The four displays surrounding the stick show
the current amounts of the primed sound for the
two front and the two rear channels:
The FrLeft value (front left) also appears in the
main display.
• After making a rough adjustment using the
stick controller, you can fine-tune all values. To
this end, scroll with the navigation stick
(stick.up/down) to the given menu options
and use the knob to define the values.
• Repeat these steps for the other sounds in the
setup.
• Start by priming each sound. In the surround
menu, navigate to the parameter surround sub
mix and boost or cut the subwoofer signal for
each sound (value ranges from 0 to 127, values
> 63 = boost, values < 63 = cut).
Surround settings are stored for each sound with the
setup.
At the same time, positioning the stick
determines the amount of the center channel.
See note on page 64.
Neuron.book Seite 175 Montag, 23. Dezember 2002 2:28 14