User Guide

144
Module: Silver
Stereo phase
(Flanger)
Delays the modulation effect in the
stereo image for spreading the left and
right channels. For example, if the effect
attains its highest frequency on the left
channel, this value determines the
"distance" of the effect’s sweep from the
left channel to the right channel.
Value range: -64 to +63.
The maximum values of +63 and -64 shift
the phase of the two channels by half of
an LFO periodic oscillation. The sign
preceding the value determines the
direction of shift between the left and
right channels.
Mix
(Phaser)
Defines the amount of delayed signal
added to the original signal, thus
determining the output signal’s wet/dry
mix.
Value range: 0 to 127.
Feedback
(Phaser)
Defines the amount of signal routed back
to the effect’s input via feedback loop.
Value range: -64 to +63.
Table 19: Silver: Time FX parameters (cont.)
Depth
(Phaser)
Determines the LFO oscillation’s
modulation depth. The higher the value,
the stronger the phaser effect.
Value range: 0 to 127.
Speed
(Phaser)
Defines the frequency of the modulating
LFO oscillation. The higher the LFO
frequency, the faster the frequency
cancellations are repeated and the faster
the effect changes.
Value range: 0.0 to 20.0 Hz in 0.1 Hz
steps.
Wave
(Phaser)
Determines the waveform of the
modulating LFO oscillation. The same
waveforms are available as in the mod
menu. You will find a list of all available
waveforms on page 118.
Table 19: Silver: Time FX parameters (cont.)
Neuron.book Seite 144 Montag, 23. Dezember 2002 2:28 14