User Guide

Neuron’s connectors and ports
9
Neuron’s connectors and ports
Before cabling up ...
• switch off all devices in the signal chain!
• read the guidelines on the following pages first
and heed the notes on safety on page 5.
• turn the volume on the connected amp / mixer
all the way down.
A word on audio quality ...
To allow your Neuron to unleash all the awesome
might of its sonic powers and our innovative
resynthesis technology to work its magic, be sure to
use premium audio devices (amps, mixers, speaker).
In other words, plug into the best gear you can
reasonably afford. Also, be sure to run Neuron in
stereo; better yet, in surround mode! Read the
comments on master volume on page 35.
Mains cord
Ensure both the mains cord and the given outlet are
the right type and in a state of good repair before
plugging the mains cord into the socket. Read also
the notes on safety starting on page 5.
Neuron may be operated at mains voltages ranging
from 100 V AC to 240 V AC only.
The device is not equipped with an 115/230V
selector, it automatically adapts to the mains
voltage if available within the aforementioned
range.
The connector panel is located on the
left side of the device! That is a nice
touch because your audience can
admire the handsome Hartmann
trademark – a very distinctive on
button – rather than a rat’s nest of
cords.
The ports are shown in detail in the
illustrations on the following pages.
Neuron.book Seite 9 Montag, 23. Dezember 2002 2:28 14