User Guide

142
Module: Silver
Time FX parameters
Pre filt cut
(Decimator)
Determines the cutoff frequency of the
low-pass filter located in front of or pre
S&H circuit. Serves to attenuate high
frequencies to generate more harmonic,
less noise-like distortion.
Value range: 0 to 127
(covers the entire frequency range)
Mix
(Sp_warp)
Determines the amount of wet signal in
the effect’s output signal (the mix of the
original signal and the frequency-inverted
signal).
Value range: 0 to 127.
Frequency
(Sp_warp)
Center frequency at which the spectrum of
the incoming audio signal is inverted.
Value range: 0 to 127.
Tilt
(Sp_warp)
Determines the down-sampling factor. The
sampling rate and pitch decreases in
accordance with this value.
Value range: 0 to 127.
Damping
(Sp_warp)
6 dB low-pass filter.
Value range: 0 to 127.
(covers the entire frequency range)
Table 18: Silver: Freq FX parameters (cont.)
Speed
(Sp_warp)
Determines the frequency of the
modulating LFO oscillation.
Value range: 0.0 to 20.0 Hz in 0.1 Hz
steps.
Depth
(Sp_warp)
Determines the LFO oscillation’s
modulation depth.
Value range: 0 to 127.
Type Defines the effect type. Your options are
stereo spread, LR delay, flanger, phaser
and chorus.
Effects are described in the section
starting on page 131.
Chan delay
(Stereo
spread)
Defines the delay time for the delayed
channel. The two channels are spread as
a function of time, so that our ears
perceive the stereo image to be wider.
Value range: -64 to +63.
Positive values delay the left channel,
negative values delay the right channel.
Table 19: Silver: Time FX parameters
Table 18: Silver: Freq FX parameters (cont.)
Neuron.book Seite 142 Montag, 23. Dezember 2002 2:28 14