User Guide

Module: Silver
141
Out Vol
(Distortion)
Determines the distorted signal’s output
level. This parameter can be used to
compensate for the signal level boosted by
In Drive.
Value range: 0 to 127.
Corresponds roughly to -infinite to 0 dB.
Mix
(Ring mod)
Determines the amount of wet or effects
signal in the output signal (the mix of the
original signal and the ring-modulated
signal).
Value range: 0 to 127.
Mod Freq
(Ring mod)
Determines the ring modulator’s carrier
frequency.
Value range: 0 to 127
Corresponds to 0 Hz to 5 kHz.
Speed
(Ring mod)
Determines the LFO oscillation frequency
for modulating the carrier frequency (mod
freq).
Value range: 0.0 to 20.0 Hz in 0.1 Hz
steps.
Depth
(Ring mod)
Determines the modulation depth of the
carrier frequency (mod freq) via the LFO
oscillation. Value range: 0 to 127.
Table 18: Silver: Freq FX parameters (cont.)
Wave
(Ring mod)
Determines the LFO oscillation’s waveform.
The same waveforms are available as in the
mod menu. You will find a list of all
available waveforms on page 118.
Xover delay
(Ring mod)
Determines the amount of delayed signal
sent back to the ring modulator’s input
from its output via feedback loop.
Value range: 0 to 127.
Xover Time
(Ring mod)
Determines the delay time for the signal
sent back to the ring modulator’s input
from its output via feedback loop.
Value range: 0 to 1000 ms.
X Dly Fdbk
(Ring mod)
Determines the amount of the signal sent
back to the ring modulator’s input from its
output via feedback loop
Value range: -64 to +63.
Mix
(Decimator)
Determines the amount of wet signal in
the effect’s output signal (the mix of the
original signal and the down-sampled
signal).
Value range: 0 to 127.
S&H factor
(Decimator)
Determines to which extent the original
signal is reduced by the sample&hold
circuit.
Value range: 0 to 127.
Table 18: Silver: Freq FX parameters (cont.)
Neuron.book Seite 141 Montag, 23. Dezember 2002 2:28 14