User Guide

140
Module: Silver
Band 1
(EQ Comp)
The parameters are only visible when Band
1 = on.
Frequencies within the band defined by Q
and surrounding the center frequency
determined by B1 freq are boosted or cut
in accordance with the B1 gain setting. Q
defines the cutoff slope: The steeper the
slope, the narrower the band-pass filter’s
band.
Value ranges:
B1 Gain: -24 to +24 dB (0.5 dB steps)
B1 Freq: 13 Hz to 20.2 kHz in semitone
steps
B1 Q: 0.1 to 10 in 0.1 steps
Band 2 see Band 1.
HighShelf
(EQ Comp)
The parameters are only visible when
HighShelf = on.
frequencies above the HS freq setting are
boosted or cut in accordance with the HS
gain setting. HS slope defines the
steepness of the shelf slope.
Value ranges:
HS Gain: -24 to +24 dB (0.5 dB steps)
HS Freq: 13 Hz to 20.2 kHz in semitone
steps
HS Slope: 0.1 to 10 in 0.1 steps
Table 18: Silver: Freq FX parameters (cont.)
B1 Gain
B1 Freq
Compressor
(EQ Comp)
The parameters are only visible when
Compressor = on.
Levels above the defined threshold are
boosted to the out gain level. Response
controls compressor reaction time as a
combination of program-driven attack and
release value.
Value ranges:
Threshold: -48 to 0 dB in 1 dB steps
Out Gain: 0 to 12 dB in 0.1 dB steps
Response: 0 to 127.
In Drive
(Distortion)
Determines the input signal’s volume. The
higher the level, the more distortion.
Value range: 0 to 127
Corresponds roughly to -infinite to +48 dB.
Pre filt cut
(Distortion)
Determines the input low-pass filter’s
cutoff frequency. Clipper is located right
after this filter’s output.
Value range: 0 to 127.
(covers the entire frequency range)
Clip Crv
(Distortion)
Determines how the incoming oscillation is
cut when the amplitude exceeds the clip
point. You have various types of curves to
choose from.
Table 18: Silver: Freq FX parameters (cont.)
Neuron.book Seite 140 Montag, 23. Dezember 2002 2:28 14