User Guide

Module: Silver
139
Freq FX parameters
Neuron can imitate this phenomenon if
filter parameter weighting is modulated by
key tracking values:
Value range: -64 to +63.
Key Track = 0: No weighting, meaning that
the cutoff frequency is not shifted.
Key Track > 0: The cutoff frequency increases
for notes above the center key (C3). The
frequency decreases for notes below C3.
Key Track < 0: The cutoff frequency
decreases for notes above the center key
(C3). The frequency increases for notes
below C3.
See also the illustration on page 85
VeloDepth Determines velocity modulation depth and
thus the intensity of its effect on the
selected filter’s cutoff frequency.
Value range: -64 to +63
VeloDepth = 0: No frequency modulation.
VeloDepth > 0: Starting at the current level,
the frequency increases in accordance with
velocity (up to a max value of 127): current
frequency + velo depth x velocity value
VeloDepth < 0: The frequency decreases in
accordance with velocity.
Table 17: Silver: Filter parameters (cont.)
Type Defines the effect type. Your options are
EQcomp, distortion, ring modulator,
decimator and Sp_warp.
Effects are described in the section
starting on page 127.
LowShelf
(EQ Comp)
The parameters are only visible when
ParamEQ = on and LowShelf = on.
Frequencies below the LS freq setting are
boosted or cut in accordance with the LS
gain setting. LS slope defines the
steepness of the shelf’s slope.
Value ranges:
LS Gain: -24 to +24 dB (0.5 dB steps)
LS Freq: 13 Hz to 20.2 kHz in semitone
steps
LS Slope: 0.1 to 10 in 0.1 steps
Table 18: Silver: Freq FX parameters
Neuron.book Seite 139 Montag, 23. Dezember 2002 2:28 14