User Guide

116
Module: Mod
Potential modulation destinations for the LFO:
• Resynators: pitch, volume and all cross-x
parameter pairs of every scape and sphere
parameter level (described in table starting on
page 77).
• Blender: amount (see page 95).
• Silver: cutoff frequency of the current filter.
(LFO depth parameter, see page 138).
Mod: Menu
After you have pressed on/off,
the mod menu appears in the
main display.
Twist the amount knob to
access the menu option
depth .
Scroll with the navigation
stick and choose the
parameter setting using the
knob.
Mod: Control features
Mod: Parameters
LFO
Switch
Amount
LFO
Depth
On/Off
LFO
Rate
LFO
Delay
LFO
Wave
Menu
On/Off
button
Switches the modulator on/off.
Amount
knob
Controls the LFO parameter depth, that is, the
amplitude of the LFO oscillation (see below).
Table 12: Mod control features
Depth Amplitude of the LFO oscillation. The higher
the amplitude, the more pronounced the
modulation effect.
You can also set the depth directly using the
amount knob.
Value range: 0 to 127.
Heads up: In this context, be sure to keep in
mind the parameter LFO depth at the respective
modulation destination:
The "global" LFO depth defined here in the mod
module is offset against the LFO depth setting
at the modulation destination.
Rate Frequency of the LFO oscillation.
Value range: 0.0 to 20.0 Hz in 0.02 Hz steps.
Table 13: Mod parameters
Neuron.book Seite 116 Montag, 23. Dezember 2002 2:28 14