User Guide

110
Module: Shaper 1/2
Shaper 1/2: Handling
How to define an amplifier envelope
• Press (repeatedly if necessary) the status
shaper button so that the amplifier LED lights
up.
Status Amp appears in the main display.
• Stick.down the navigation stick to access the
menu option mode, which lets you select the
envelope mode.
• Adjust ADSR parameter values by turning the
wheels. Once you move a wheel, you can also
define the given value in the main display using
the knob.
Alternatively, you can navigate via stick.right/
left back and forth among individual envelope
parameters.
How to define a parameter envelope
• Activate the parameter envelope by pressing
the contour contr. button (repeatedly if
necessary) in the given resynator so that the
shaper LED lights up.
• Press (repeatedly if necessary) the status
shaper button until the par. levels LED lights up.
Status ParLevel appears in the main
display.
Mode Defines the envelope mode. The mode can be
selected for every envelope type and in every
status.
• Normal: Playing a note triggers the envelope
once only.
• Repeat: Playing a note triggers the
envelope. In the case of ADSR curves, a new
cycle’s attack phase is launched after the
release phase ends.
A 4L/4T curve goes from level 4 to level 1
within the time defined for time 4.
For more on this, read page 103.
Level /
time
The parameters of a 4 levels 4 times envelope
are described on page 100.
Type The type parameter is available only in free
shaper status. It lets you select the desired
type of free envelope:
• 2ADSR: An ADSR envelope is defined for
each shaper, which can then be routed to
different modulation destinations. For more
on this, read page 104.
• 4L4T: The two shapers are combined to
define a 4 levels 4 times envelope, which
can also be assigned to different
destinations. For detailed information on
the 4L4T curve, check out page 100.
Table 11: Shaper 1/2 parameters (cont.)
Neuron.book Seite 110 Montag, 23. Dezember 2002 2:28 14