User Guide

Module: Shaper 1/2
109
The parameter envelope (par levels shaper
status) can be defined selectively for every
scape and sphere parameter level. See also
page 104.
Value range: -64 to +63.
Depth = 0: No modulation.
Depth > 0: Modulation adds to target
parameter values.
Depth < 0: Modulation subtracts from target
parameter values.
Depth is variable for each shaper when you
use two free ADSR envelopes (free > 2ADSR).
If you opt for one 4 levels 4 times curve,
there is of course just one depth parameter
(adjustable via both depth knobs).
Good-to-know stuff: The depth at the
modulation destination is of relevance when
using free envelopes! The two depth values
are offset against each other.
You will find further information about this
topic on page 104.
You can also control depth via velocity: see
the following parameter velo depth.
Table 11: Shaper 1/2 parameters (cont.)
Velo
Depth
The depth parameter (page 108) defines the
intensity of the envelope’s effect on other
Neuron modules. The velo depth parameter
lets you manipulate depth manually by
varying key pressure. There you have it - a
modulation of a modulation...
Value range: -64 to +63.
VeloDepth = 0: Depth is not modulated.
VeloDepth >0: Depth increases in accordance
with velocity (up to a max value of 127):
current parameter value + velo depth x
velocity value
The harder you strike the keys, the greater the
depth of the envelope.
VeloDepth = 63: Maximum effect of velocity
on the depth of the envelope.
VeloDepth <0: Depth decreases inversely to
velocity. The harder you strike the keys, the
weaker the envelope’s influence.
A value of -64 denotes the maximum inverse
effect of velocity on the depth of the
envelope.
This parameter is not available for the
amplifier envelope because it does not have a
depth parameter.
Table 11: Shaper 1/2 parameters (cont.)
Neuron.book Seite 109 Montag, 23. Dezember 2002 2:28 14