8 x10″ Stackable Aluminum Drive Bass Enclosure Hartke
810XL Introduction and Features Congratulations on purchasing the 810XL bass enclosure by Hartke! The XL Series enclosures have been designed to provide excellent tone with a fast attack, deep low-end and punchy output. The 810XL Features eight 10”, proprietary low frequency drivers with specially designed aluminum cones, large voice coils on Kapton formers, impregnated fabric surrounds, and matched convex dust covers all mounted in a heavy-duty steel frames.
Connecting the 810XL About Impedance Before you hook up your speaker cabinet, be sure that you understand a little about impedance. Impedance is the electronic load that the speaker puts on the power amplifier and is measured in Ohms. Here is the tricky, yet simple rule of impedance: When two speakers are wired in "Parallel" the total impedance is cut in half and when two speakers are wire in “Series” the total impedance is the sum of the speakers individual impedance.
Specifications Hartke 810XL Specifications Type Impedance Power Handling Drivers SPL Frequency Response Input Weight Dimensions Tuned, Sealed Enclosure 4 Ohms 800 Watts RMS Power Handling 8 - Hartke 10XL8 Special Design Aluminum 10", 8 ohm, 100 watt drive units 100dB @ 1W/1M 40Hz - 5kHz 1/4” Phone jack 145 lbs. (65.77 kg) Height:48" (121.92 cm) Width: 24" (60.96 cm) Depth: 16" (40.64 cm) Hartke Distributed Worldwide Exclusively by: Samson Technologies Corp. 575 Underhill Blvd. P.O.