User manual

7
Guided Tour - 2500 Rear Panel
5. Effect Send jack - Use this 1/4” unbalanced jack to send low impedance (100
ohm) signal from the Model 2500 to a professional outboard effects processor
such as a reverb, echo, chorus, flanger, or harmonizer device.* Output level is
approximately 0 dB to +4 dB and is post-EQ and post-compression but unaffected
by the setting of the Master Volume control. You can also use the Effect Send jack
to route signal to an external mixing console or amplifier with an input sensitivity
of +4 dB.
6. Speaker outputs - Connect any 4, 8, or 16 ohm bass cabinet(s) to these
standard unbalanced 1/4” jacks. WARNING: Because of the high power levels
and low frequency content of the signal generated by the Model 2500, use
only appropriately rated speaker cabinets (at least 250 watts at 4 ohms) that
are specifically designed for bass instruments. We recommend that Hartke
amplifiers be used with Hartke bass cabinets, although other brands of speak
-
ers can be used.
* In-line effects (such as footpedals) intended for low signal levels should be
placed between the bass and the amplifier Input and not connected with the
Effect Send and Return jacks.
** Note that the settings of the ten-band graphic equalizer will affect a “Post”
Direct Out signal regardless of the position of the front panel In/Out switch.