Brochure
Englsih
Ⓐ
Ⓑ
Ⓒ
Ⓓ
Accessories
Table 4: Accessories for the four-indent crimp tool
Operating instructions
Checking with the go / no-go gauge
1. Open the crimp tool (refer to the preparing the crimp
tool section on page 18).
2. Pull out the settings dial and turn it until the scale on the
back of the crimp tools shows the number 1.5. Release
the settings dial; give it a brief turn so that it latches back
into place.
3. Check the dimensions of the prole by inserting the
go / no-go gauge (Ⓐ = front, Ⓑ = back) into the opening!
▸ It should be possible to insert the "go" side Ⓒ; it should
not be possible to insert the "no-go" side Ⓓ.
Your crimp tool must be re-adjusted by the manufactu-
rer if it does not pass this test!
Accessories
Identication Part number
Spare locator 09 99 000 0887
Go / no-go gauge 09 99 000 0889
23
Operating Instructions: HARTING Four-Indent Crimp Tool / Edition 1.0