Datasheet

30
.
10
02 99 000 0007
09 99 000 0278
Tooling
Repair tooling
Identification for use with Part number Drawing Dimensions in mm
rear
I/O shroud
har-bus
®
64
rear
I/O shroud
Type C, 2C
R, 2R
Removal tool
for shroud
Replacement of complete har-bus
®
64 press-in connectors
Steps in detail
1. Lever up the moulding by using a removal tool
a)
The removal tool with Part number 02 99 000 0003 is suitable for repairing small quantites. It can only
be used if the adjacent components on the pcb are at least 2 mm apart from the moulding of the con
-
nector.
b) The removal tool with Part number 02 99 000 0006 is suitable for repairing large quantities. Due to
its design it can also be used if components on the pcb are in close proximity to the moulding of the
connector.
2.
Lever up the rear I/O shroud with the removal tool 02 99 000 0007. This step is only required with 17 mm
termination length.
3. Pull out the female contacts with the press-out tool
a) for 17 mm termination length use Part number 02 99 000 0004 and
b) for 5 mm termination length use Part number 02 99 000 0008.
During this process the press-out tool replaces the top tool and the pcb is supported by the support block
(Part number 02 99 000 0005) from the bottom.