Manualshelf

Install Instructions

ManualsBrandsHart & Cooley ManualsPlumbing Supplies8" Adjustable Intermediate Wall Support (8TLCIWS)
12
THE BEST THERE IS!
Model TLC
Model TLC
Installation Planning Guide
Getting Started
The inner diameter of your
chimney is usually the same
size (6" or 8") as the flue
collar on your wood stove.
Before you begin, determine the
(inner) diameter of your chimney.
Model TLC
Your Complete Wood Stove Chimney Solution!
Your Complete Wood Stove Chimney Solution!
Step 2 Helpful Installation Tips
Step 3
Step 4 Offset Calculation for Ceiling Support Installations Only
Step 5
Need help?
Contact us at 1-800-433-6341
Or, visit us online at www.hartandcooley.com
©
Hart & Cooley, Inc. Form No. 851511 1M 04/2009
Determine the number of Chimney Lengths
required. Chimney Lengths are available
in 48", 36", 24", 18", 12" and 6" lengths.
The chimney must extend at least 3' above the highest
point where it passes through the roof surface and at
least 2' higher than any part of the building within a
horizontal distance of 10'.
If an offset is required
to avoid rafters or
other obstructions,
measure the
horizontal distance
required and the
vertical height
available. Refer to the
Chimney Offset Chart
to determine the
Elbow and Chimney
Length required.
NOTE:
When calculating the
installed length of your
chimney, subtract 1
1
/8"
for each joint and include
the height requirements
as shown in this
illustration.
To calculate your roof
pitch, use one of the
12-inch rulers to
measure the number
of inches (A) from the
end of the other ruler
down to the roof.
Choose the proper Roof Flashing required for your installation.
The final step required to complete your Wood Stove chimney installation is to determine the double-wall or single-
wall black stovepipe parts that will be needed to transition from the TLC chimney to your wood stove outlet.
To determine which Roof Flashing you require, work out
the pitch of your roof.
6" Chimney Diameter:
0/12 - 6/12 Roof Pitch =
6TLCF6 (Low Slope)
6/12 - 12/12 Roof Pitch =
6TLCF12 (Steep Slope)
8" Chimney Diameter:
0/12 - 6/12 Roof Pitch =
8TLCF6 (Low Slope)
6/12 - 12/12 Roof Pitch =
8TLCF12 (Steep Slope)
NOTE:
For metal roof, use Universal Rubber Boot Flashing Kit =
TLCRBF.
Roof Flashing Selection Chart
Chimney Offset Chart

Summary of content (2 pages)