User's Manual
Table Of Contents
- 1 SAFETY SYMBOL CONVENTIONS
- SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 6.2.1 Installing NMO Antenna Mounts AN125001-001, 002, 003 and 004
- 6.2.2 Installing NMO Magnetic Antenna Mounts AN125001-007 and AN125001-008
- 6.2.3 Installing All Other Antenna Mounts
- 6.2.4 Attaching NMO Antenna Elements
- 6.2.5 Installing the Coax Cable and TNC RF Connector
- 6.2.6 Install GPS Antenna (Required Only if Radio has GPS Receiver Option)
- 7 RADIO INSTALLATION
- 8 CH25 REMOTE CONTROL HEAD INSTALLATION
- 9 EXTERNAL SPEAKER INSTALLATION (OPTIONAL)
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES
- 12 GPS NMEA-FORMATTED DATA CONNECTION
- 13 MOBILE DATA CONNECTION
- 14 INITIAL POWER-UP TEST
- 15 PERFORMANCE TESTS
- 16 COMPLETE THE INSTALLATION
- 17 WARRANTY REGISTRATION
- 18 WARRANTY
14221-1510-4440, Rev. B
8
Microphone Audio Frequency Response: ±0.5 dB from 100 Hz to 3000 Hz
Microphone Connector: 12-pin locking connector located on front panel
Speaker Audio Output Power
Internal Speaker: 3 watts RMS (8-ohm speaker)
External Speaker (Optional): 15 watts RMS into a 4-ohm speaker
Speaker Audio Output Distortion
Internal Speaker: < 3% at 3 watts RMS audio output
External Speaker (Optional): < 3% at 15 watts RMS audio output
2.3 REGULATORY
2.3.1 General
FCC Type Acceptance
VHF Radio: OWDTR-0075-E
UHF Radio: OWDTR-0077-E
700/800 MHz Radio: OWDTR-0076-E
Industry Canada Certification
VHF Radio: 3636B-0075
UHF Radio: 3636B-0077
700/800 MHz Radio: 3636B-0076
Applicable Industry Canada Rules: RSS-119
2.3.2 FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference; and,
2. This device must accept any interference received, including interference that may cause undesired
operation.
2.3.3 Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.










