User's Manual
Table Of Contents
- 1 SAFETY SYMBOL CONVENTIONS
- SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 6.2.1 Installing NMO Antenna Mounts AN125001-001, 002, 003 and 004
- 6.2.2 Installing NMO Magnetic Antenna Mounts AN125001-007 and AN125001-008
- 6.2.3 Installing All Other Antenna Mounts
- 6.2.4 Attaching NMO Antenna Elements
- 6.2.5 Installing the Coax Cable and TNC RF Connector
- 6.2.6 Install GPS Antenna (Required Only if Radio has GPS Receiver Option)
- 7 RADIO INSTALLATION
- 8 CH25 REMOTE CONTROL HEAD INSTALLATION
- 9 EXTERNAL SPEAKER INSTALLATION (OPTIONAL)
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES
- 12 GPS NMEA-FORMATTED DATA CONNECTION
- 13 MOBILE DATA CONNECTION
- 14 INITIAL POWER-UP TEST
- 15 PERFORMANCE TESTS
- 16 COMPLETE THE INSTALLATION
- 17 WARRANTY REGISTRATION
- 18 WARRANTY
14221-1510-4440, Rev. B
56
11.4 DESK MIC ADAPTER CABLE 14015-0200-02
Desk Mic Adapter Cable 14015-0200-02 can be used to connect a desk microphone, such as part number
MC-014121-003. This cable interconnects the radio’s front panel mic connector to the desk mic’s DB-9
connector. Cable assembly and wiring diagrams are shown in Figure 11-4 below.
The cable’s circular (LTW) connector mates to the radio’s mic connector, and its female DB-9 connector
mates to the male DB-9 connector of the desk mic.
(Made From D14015-0200-PS Rev. A)
Figure 11-4: Desk Mic Adapter Cable 14015-0200-02