User's Manual
Table Of Contents
- 1 SAFETY SYMBOL CONVENTIONS
- SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 6.2.1 Installing NMO Antenna Mounts AN125001-001, 002, 003 and 004
- 6.2.2 Installing NMO Magnetic Antenna Mounts AN125001-007 and AN125001-008
- 6.2.3 Installing All Other Antenna Mounts
- 6.2.4 Attaching NMO Antenna Elements
- 6.2.5 Installing the Coax Cable and TNC RF Connector
- 6.2.6 Install GPS Antenna (Required Only if Radio has GPS Receiver Option)
- 7 RADIO INSTALLATION
- 8 CH25 REMOTE CONTROL HEAD INSTALLATION
- 9 EXTERNAL SPEAKER INSTALLATION (OPTIONAL)
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES
- 12 GPS NMEA-FORMATTED DATA CONNECTION
- 13 MOBILE DATA CONNECTION
- 14 INITIAL POWER-UP TEST
- 15 PERFORMANCE TESTS
- 16 COMPLETE THE INSTALLATION
- 17 WARRANTY REGISTRATION
- 18 WARRANTY
14221-1510-4440, Rev. B
47
3. Route the cable through the vehicle’s interior to near the location of the control head. Remove interior
panels, door kick panels, etc., and route the cable through existing channels in the vehicle body as
necessary.
4. Connect the other 44-pin connector of the Remote Control Cable to the 44-pin connector on the rear
panel of the control head. Tighten the jackscrews securely, but do not over-tighten them. Be sure to
leave a service loop in the cable so when control head removal is necessary, movement will not be
unnecessarily limited.
5. Tie and stow all excess cable length so it will be out of casual contact with vehicle occupants. Be sure
to protect it from wire chafe where necessary.
6. Re-install all previously removed interior panels, door kick panels, etc.