User's Manual
Table Of Contents
- 1 SAFETY SYMBOL CONVENTIONS
- SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 6.2.1 Installing NMO Antenna Mounts AN125001-001, 002, 003 and 004
- 6.2.2 Installing NMO Magnetic Antenna Mounts AN125001-007 and AN125001-008
- 6.2.3 Installing All Other Antenna Mounts
- 6.2.4 Attaching NMO Antenna Elements
- 6.2.5 Installing the Coax Cable and TNC RF Connector
- 6.2.6 Install GPS Antenna (Required Only if Radio has GPS Receiver Option)
- 7 RADIO INSTALLATION
- 8 CH25 REMOTE CONTROL HEAD INSTALLATION
- 9 EXTERNAL SPEAKER INSTALLATION (OPTIONAL)
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES
- 12 GPS NMEA-FORMATTED DATA CONNECTION
- 13 MOBILE DATA CONNECTION
- 14 INITIAL POWER-UP TEST
- 15 PERFORMANCE TESTS
- 16 COMPLETE THE INSTALLATION
- 17 WARRANTY REGISTRATION
- 18 WARRANTY
14221-1510-4440, Rev. B
42
10. Obtain the 3-amp AGC-type fuse included with the cable, and install it into the fuse holder.
11. Tie and stow these wires as necessary so they remain out of the way of casual contact and wire chafe
is avoided.
12. Label this power switch accordingly. For example: “RADIO ON/OFF.”
7.2.2.3.3 Radio and Control Head are “Hot Wired”
In the “hot-wired” configuration, the radio and control head are turned on and off only by the head’s
on/off/volume control. In this configuration, the white wire must be connected to unswitched and fused
12-volt vehicle power. Follow the procedure presented in Section 7.2.2.3.1, except connect the white wire
to unswitched battery power instead of switched (“Accessory”) power. Be sure to fuse this connection
with the provided in-line fuse holder and 3-amp AGC fuse.