User's Manual

14221-1510-4440, Rev. B
37
TOP VIEW ISOMETRIC VIEW
FRONT/REAR VIEW
(Made From D14015-0201 Rev. -)
Figure 7-3: Mounting Bracket 14015-0201-02 Dimensions (Radio Not Shown)
7.1.4 Inserting the Radio into the Mounting Bracket
The radio should now be inserted into the mounting bracket according to this procedure:
1. Lay the radio into the mounting bracket with the front of the radio facing in the correct direction
(usually towards the rear of the vehicle).
2. Secure the radio to the bracket using the four (4) M5 x 10 mm stainless-steel socket-head screws, flat
washers, and lockwashers. Each screw should have a lockwasher against the screw head and a
flatwasher against the mounting bracket. This hardware is included with the Mounting Bracket Kit.
The kit’s contents are shown in Figure 7-2. The kit is Item 1 listed in Table 4-2 (page 13).
3. Tighten all screws using a 3-millimeter hex key wrench until each lockwasher is fully compressed
and the radio is firm and flush between the brackets.
4. Check the mounting area for proper clearance for cable service looping and for air circulation, plus an
area to secure and rest the excess cable lengths.
Proper mounting is one factor that ensures optimal radio performance. An improperly
mounted radio may experience degradation in the quality of voice and data
communications.
2.75 Inches
(69.9 mm)
1.77 Inches
(45.0 mm)
2.75 Inches
(69.9 mm)
1.77 Inches
(45.0 mm)
0.98 Inches
(25.0 mm)
0.98 Inches
(25.0 mm)
6.77 Inches
(172.0 mm)
2.63 Inches
(66.8 mm)
NOTE
Bracket-To-Radio Screw Holes
(12 places, 6 each side)
Bracket-To-Vehicle
Screw Holes (11 places)