User Manual

MM-014716-001, Rev. E
30
7.13 BASIC MENU STRUCTURE
Table 7-4 illustrates the basic M7300 OpenSky menu structure. Menu items vary depending upon system
programming, radio hardware, and optional configurations. All menus except the dwell display menu can
be turned off by network administration personnel.
Table 7-4: Basic Menu Structure
MENU NAME
RADIO DISPLAYS
(TOP AND BOTTOM LINES)
USAGE NOTES
To/From Dwell Display
, CLR, or OPT
Engineering Display
bit-error rates
and RSSI data
Displays radio system connection data. For engineering use.
, CLR, or OPT
Silent Emergency
“SilentEmerg”
Use
to toggle Silent Emergency “On” or “Off.”
, CLR, or OPT
Operating Mode
“App Mode”
Use
to choose an available mode (OTP, ECP, or OCF). Press
MENU and confirm (Y/N) with
and press MENU again.
, CLR, or OPT
GPS Fix
“GPS Fix”
Radio’s current GPS latitude and longitude position scrolls across top
line of the display. Applies to GPS-equipped radios only.
, CLR, or OPT
User ID
“User ID”
User’s identification/name scrolls across top line of the display (if
programmed).
, CLR, or OPT
IP Address
“IP Address”
Radio’s Internet Protocol (IP) address scrolls across top line of the
display.
, CLR, or OPT
Station Identification
“Station ID”
Station’s identification/name scrolls across top line of the display (if
programmed).
, CLR, or OPT
Stealth Mode
“StealthMenu”
Use
to turn Stealth Mode “On.”
, CLR, or OPT
Treble Level
“Treble Menu”
Use
to choose speaker/headset treble level (LOW, MEDIUM,
MEDHIGH, or HIGH). Press Select to return to dwell display.
, CLR, or OPT
Display Brightness
“Bright Menu”
Use
to dim or brighten. Press MENU to return to dwell display.
, CLR, or OPT
Side Tone Level
“Side Menu”
Use
to choose side tone level (Off, Low, Med, or High). Press
MENU to return to dwell display.
, CLR, or OPT
Intercom
“Intercom”
Use
to turn intercom “On” or “Off.” Press MENU to return to
dwell display.
, CLR, or OPT
See Next Page