User Manual
Table Of Contents
- 1 REGULATORY AND SAFETY INFORMATION
- 1.1 SAFETY SYMBOL CONVENTIONS
- 1.2 RF ENERGY EXPOSURE AWARENESS AND CONTROL INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS
- 1.3 COMPLIANCE WITH RF EXPOSURE STANDARDS
- 1.4 REGULATORY APPROVALS
- OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING INFORMATION
- 1.6 COMMON HAZARDS
- 1.7 SAFE DRIVING RECOMMENDATIONS
- 1.8 OPERATING RULES AND REGULATIONS
- 1.9 OPERATING TIPS
- 2 SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 7 FRONT-MOUNT RADIO INSTALLATION
- 8 REMOTE-MOUNT RADIO INSTALLATION
- 8.1 MOUNTING THE REMOTE-MOUNT RADIO
- 8.2 REMOTE-MOUNT RADIO’S DC POWER INSTALLATION
- 8.3 CONTROL HEAD INSTALLATION
- 8.3.1 General Information on the CH100 Control Head
- 8.3.2 General Information on the CH721 Control Head
- 8.3.3 Multi-Head Radio Installations
- 8.3.4 Control Head Mechanical Installation
- 8.3.5 Control Head-to-Radio CAN Cable Connections
- 8.3.6 Control Head Power Cable Installation
- 8.3.7 Using Vehicle Fuse and TTap Kit (Optional) Instead of Waterproof Inline Fuse Holder (Standard)
- 9 SPEAKER INSTALLATION
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES AND CONNECTIONS
- 12 GPS NMEA-FORMATTED DATA CONNECTION
- 13 INITIAL POWER-UP TEST
- 14 PERFORMANCE TESTS
- 15 COMPLETE THE INSTALLATION
- 16 WARRANTY REGISTRATION
- 17 WARRANTY
14221-1200-4000, Rev. A
15
Microphone Types Available: Standard, DTMF, and Noise-Canceling
Speaker Audio Output Power: 15 watts RMS minimum into 4-ohm external speaker
Speaker Audio Output Distortion
CH-100 Control Head: < 3% at 15 watts RMS into 4-ohm external load
CH-721 Control Head: < 5% at 15 watts RMS into 4-ohm external load
Headset Audio Output Power
At CH-100 Microphone Connector: 0.5 watts minimum into 4-ohm headset/speaker
At CH-100 DB-25 Rear Panel Connector: 35 milliwatts maximum into 24-ohm headset
At CH-721 Microphone Connector: 0.5 watts minimum into 4-ohm headset/speaker
At CH-721 DB-25 Rear Panel Connector: 35 milliwatts maximum into 24-ohm headset
External Speaker Connection
Local Control (Front-Mount Radio): 2-pin audio connector on radio’s option cable
Remote Control (Remote-Mount Radio): 2-pin audio connector on rear of control head
Mic A-D and Speaker D-A Audio Conversion
CODEC Audio Sampling Rate: 8 kHz
CODEC Algorithm (Vocoding Method): Sigma-Delta (
∑∆)
Voice-Coding Method
P25 Phase 1 Mode: Improved Multi-Band Excitation (IMBE
®
)
Data Rate
P25 Mode: 4800 symbols/second
2.3 REGULATORY
FCC Type Acceptance: AQZ-XG-100M00
Applicable FCC Rules: Part 15, Part 80 and Part 90
Industry Canada Certification: 122D-XG100M00
Applicable Industry Canada Rules: RSS-119