User's Manual

14221-1200-4010, Rev. B
38
Figure 7-4: Assembly into Stack Brackets (Exploded View)
To Mount LBPA and MRU in Separate Base Brackets:
Install the LBPA and the MRU into their individual base brackets using the following procedure. An
exploded view assembly diagram is shown in Figure 7-5.
1. Slide the mobile radio between the sides of Base Bracket FM103111V1. The connector of the radio
must face towards the cabling area of the radio installation.
2. Secure the radio into the bracket using six (6) M5 Philips-head screws (SC-018424), three (3) screws
per radio side.
These screws have a captive-type (SEMS) lock washer. Tighten all six (6) screws with a screwdriver
until the lock washer on each screw is fully compressed, and the radio is firm and flush between the
bracket sides.
3. Slide the LBPA into its Base Bracket 1000003678. The connector end of the LBPA must face
towards the cabling area of the installation.
MRU Radio
(XG-100M)
Low Band PA
(XG-100LPA)
Screw, M5 x 10mm
(SC-018424) 6x
Extension Bracket
(FM-018205)
Screw, M5 x 10mm
(SC-018424) 6x
Screw, #8-32
(AD00006) 4x
Base Bracket
(1000003678)