User's Manual

14221-1200-4010, Rev. B
35
TOP VIEW SIDE VIEW
Dimensions are in Inches
Figure 7-2: Base Bracket FM103111V1 in Bracket Kit KT23117
When installed in a bracket, the radio and LBPA protrude several inches from the bracket’s front and
back edges. Therefore, when selecting an exact mounting location, verify sufficient distance at the front
and back for this plus additional clearance. A minimum distance of three (3) inches is required from the
rear edge of the bracket; however, four (4) inches or more is recommended to make radio installation and
removal easier. A minimum distance of two (2) inches is recommended from the front edge of each
bracket. The Extension Brackets are left/right symmetrical and the Base Brackets are front/back
symmetrical.
Bracket-To-Vehicle
Mounting Surface Screw
Holes (4 places)
Bracket-To-Radio Screw Holes
(6 places, 3 each side)